Skip to main content
NetApp Knowledge Base

"system health subsystem show" shows "SAS-connect_Cluster unknown" after system reboot

Views:
1,853
Visibility:
Public
Votes:
2
Category:
disk-shelves
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • NS224 Shelf
  • Direct attached storage

Issue

  • MixedDomainFromSwitchToShelf_Alert messages:

[node_name: schmd: hm.alert.raised:alert]: Alert Id = MixedDomainFromSwitchToShelf_Alert , Alerting Resource = switch_name-a(ABC123456D7) raised by monitor system-connect

[node_name: schmd: hm.alert.raised:alert]: Alert Id = MixedDomainFromSwitchToShelf_Alert , Alerting Resource = switch_name-b(ABC123456D8) raised by monitor system-connect

  • System health alert

::> system health alert show
            Node: node_name
        Alert ID: MixedDomainFromSwitchToShelf_Alert
        Resource: Switch name: switch_name-a(ABC123456D7)
        Severity: Minor
 Indication Time: Tue Jan 10 12:10:02 2023
        Suppress: false
     Acknowledge: false
  Probable Cause: Storage Switch switch_name-a is connected to shelves 3.20,
                  3.30 with mixed domains.
 Possible Effect: This issue will affect conversions to direct-attached
                  storage.
 Corrective Actions: Connect the switch node_name to both shelves with the
                  same storage domain, following the guide applicable to
                  your shelf.
            Node: node_name
        Alert ID: MixedDomainFromSwitchToShelf_Alert
        Resource: Switch name: switch_name-b(ABC123456D8)
        Severity: Minor
 Indication Time: Tue Jan 10 12:10:02 2023
        Suppress: false
     Acknowledge: false
  Probable Cause: Storage Switch switch_name-b is connected to shelves 3.20,
                  3.30 with mixed domains.
 Possible Effect: This issue will affect conversions to direct-attached
                  storage.
 Corrective Actions: Connect the switch node_name to both shelves with the
                  same storage domain, following the guide applicable to
                  your shelf.
2 entries were displayed.

  • "system health subsystem show" shows "SAS-connect_Cluster  unknown" after system reboot Example:

::> system health subsystem show
 Subsystem Health
 ----------------- ------------------
 SAS-connect ok
 ...
 FHM-Bridge ok
 SAS-connect_Cluster  unknown
 13 entries were displayed.

::*> system health subsystem show -instance -subsystem SAS-connect_Cluster
                Subsystem: SAS-connect_Cluster
                   Health: unknown
     Initialization State: start_discovery
Number of Outstanding Alerts: 0
 Number of Suppressed Alerts: 0
                     Node: node_name
  Subsystem Refresh Interval: 30m

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.