Skip to main content
NetApp Knowledge Base

"network port show" reports speed as auto/- for Virtual port (ifgrp/vlan)

  1. Last updated
  2. Save as PDF
Views:
783
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • ifgrp / vlan

Issue

"network port show" command displays the operation speed of the virtual ports ( VLAN / IFGRP) as "-"

CLUSTER01::> network port show
Node: NODE01
                                           Speed(Mbps)        Health
Port      IPspace      Broadcast Domain Link MTU  Admin/Oper  Status
--------- ------------ ---------------- ---- ---- ----------- ---------
a0e       Default      Default          up   1500  auto/-     healthy
a0e-1003  Default      bd1              up   1500  auto/-     healthy
a0f       Default      Default          up   1500  auto/-     healthy
a0f-1003  Default      bd2              up   1500  auto/-     healthy

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.