Skip to main content
NetApp Knowledge Base

ifconfig does not work after cf takeover, ethernet interface(s) down on taken over node

  1. Last updated
  2. Save as PDF
Views:
773
Visibility:
Public
Votes:
0
Category:
data-ontap-8
Specialty:
core
Last Updated:

​ ​

Applies to

  • Data ONTAP 8 7-Mode

Issue

Check Active IQ if this impacts your systems

  • Ethernet interfaces do not come up after a cluster takeover event and ifconfig cannot be used to bring up interface on taken over node partner shell.
  • Using ifconfig via the partner shell on the active node gives the following output:

filer2/filer1> ifconfig e0a `hostname`-e0a netmask 255.255.255.0 trusted -wins partner e0a
ifconfig: e0a: no such interface
filer2/filer1> Thu Sep 2 09:46:53 EDT [filer2/filer1: net.ifconfig.noPartner:error]: ifconfig: e0a cannot be configured: Address does not match any partner interface.

  • The problem interface(s) do not show up via the partner shell when issuing ifconfig -a

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.