Skip to main content
NetApp Knowledge Base

Can a paused volume encryption conversion job be cancelled?

  1. Last updated
  2. Save as PDF
Views:
586
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9
  • NetApp Volume Encryption (NVE)

Answer

  • No; once a conversion operation is started, it must complete.  The process cannot be cancelled.
  • If performance issues are encountered during the operation, run volume encryption conversion pause to pause the operation, then volume encryption conversion resume command to resume once system load decreases.
  • Starting with ONTAP 9.12.1, the conversion will continue where it left off.  In previous ONTAP releases, the resume requires the conversion to start over on the volume.
  • Alternatively, follow the Enable encryption on an existing volume with the volume move start command procedure.

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.