Skip to main content
NetApp Knowledge Base

Adding a CIFS preferred-DC fails with "RPC Error" in ONTAP

  1. Last updated
  2. Save as PDF
Views:
748
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
NAS
Last Updated:

Applies to

  • ONTAP 9
  • CIFS

Issue

  • The cifs domain preferred-dc add command fails with either of the following two errors:
    • RPC failure "Socket is not connected" occured during the CIFS preferred-dc configuration validation for Vserver "irv_svm16_netapp_admin" with domain "development.enterprise.sscims.com". Wait a few minutes, and then try the command again
    • RPC failure "No such file or directory" occured during the CIFS preferred-dc configuration validation for Vserver "irv_svm16_netapp_admin" with domain "development.enterprise.sscims.com". Wait a few minutes, and then try the command again
  • Secd reports the error: RESULT_ERROR_SECD_RPC_LIBRARY_ERROR:6902

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.