Skip to main content
NetApp Knowledge Base

Will the ATTO Bridge require a Firmware Upgrade before the Disk Shelf?

  1. Last updated
    Feb 17, 2020
  2. Save as PDF
Views:
437
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
MetroCluster
Last Updated:
2/17/2020, 3:40:19 PM

​ ​ ​  

Applies to

  • ATTO 6500N FibreBridge
  • ATTO 7500N FibreBridge
  • ATTO 7600N FibreBridge

Answer

There are no dependencies between the ATTO FibreBridge firmware and shelf firmware.

Additional Information

All dependencies between the ATTO FibreBridge firmware and shelf as well as switch firmware are documented in

  • the Interoperability Matrix Tool (IMT) for ONTAP 9.5 and earlier
  • Hardware Universe (HWU) for ONTAP 9.6 and later.

 

 

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.