Skip to main content
NetApp Knowledge Base

Disk bad label after "metrocluster configuration-settings connection connect"

  1. Last updated
  2. Save as PDF
Views:
488
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

​ ​

Applies to

  • AFF A220
  • MetroCluster IP
  • Advanced Disk Partitioning (ADP) 

Issue

Remote drives marked "Bad Label" immediately after running "metrocluster configuration-settings connection connect" 

Event log reports the following

raid.assim.disk.nolabels:EMERGENCY]: Disk XX Shelf X Bay XX [NETAPP   X] S/N [X] UID [X] has no valid labels. It will be taken out of service to prevent possible data loss.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.