Skip to main content
NetApp Knowledge Base

Source and Destination volumes stays in DP state after DR activity

  1. Last updated
  2. Save as PDF
Views:
52
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • Snapmirror

Issue

  • After a DR activity of a volume-level Snapmirror replication, both Source (Prod) and Destination (DR) volumes shows type DP.

Please find the logs below:

Prod::> vol show vol_src
Vserver   Volume       Aggregate    State      Type       Size  Available Used%
--------- ------------ ------------ ---------- ---- ---------- ---------- -----
svm1       vol_src      aggr_src     online     DP     200GB     57.09GB  42%

DR::> vol show vol_dr
Vserver      Volume     Aggregate     State    Type    Size     Available Used%
--------- ------------ ------------ ---------- ---- ---------- ---------- -----
svm2         vol_dst     aggr_dst     online    DP     200GB     57.09GB   42%

  • Predefined Command/Script was used to perform the DR activity using, which used API calls.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.