Skip to main content
NetApp Knowledge Base

Volume snaplock "modify" or "move" fails with error

  1. Last updated
  2. Save as PDF
Views:
1,078
Visibility:
Public
Votes:
2
Category:
ontap-9
Specialty:
dp
Last Updated:

Applies to

SnapLock

Issue

  • Volume snaplock modify  command returns an error as below.

::> volume snaplock modify -vserver svm1 -volume vol01_snaplock -privileged-delete enabled

Error: command failed: Audit logging is not configured for Vserver "svm1".
 
  • Snaplock volume move command fails with the error as below.

::> vol move start -vserver <vserver> -volume <volume> -destination-aggregate <destination_aggr>

Error: command failed: Unable to move volume "volume" in Vserver "vserver". Audit log volume must be configured for the Vserver before a SnapLock volume can be moved.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.