Skip to main content
NetApp Knowledge Base

E-Series SANtricity mapping not possible for Default Cluster via Web GUI

  1. Last updated
  2. Save as PDF
Views:
155
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

Netapp SANtricity OS 11.60.2R1

Issue

Unable to Assign Volume due to error message which advises Data Assurance be disabled before assigning Volume. 

Disable Data Assurance to Assign Volume 

The default cluster has at least one host port that is connected to the storage array through an I/O interface that is NOT data assurance (DA) capable. However, The following volumes have data assurance (DA) enabled. If you want to assign these volumes to default cluster, the DA capability must be disabled on the Volumes. 

Important: disabling data Assurance Protection is an irreversible action. Once disabled, you cannot re-enable it.
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.