Skip to main content
NetApp Knowledge Base

Sending SNMP test trap fails

Views:
204
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

  • E-Series
  • E2800

Issue

Sending SNMP trap destination test message via Santricity System Manager GUI fails with the following error:
The operation cannot be completed because the specified SNMP trap destination is not reachable with the current controller IPV4 network configuration. This could be because:
(1) IPV4 is not enabled on at least one port with an active connection on each controller OR
(2) the following conditions exist on one or both controllers:
    (a) the controller is configured with a static IP address (i.e. does not obtain it's IP configuration via DHCP) AND
    (b) an IPV4 gateway is not assigned on that controller AND
    (c) the IP address of the controller and the specified trap destination address are not part of the same subnet

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.

 

  • Was this article helpful?