Skip to main content
NetApp Knowledge Base

How to reset an E-Series array to initial configuration settings on 26xx, 54xx, 55xx, 27xx and 56xx platforms

Last Updated:

Applies to

  • NetApp E-Series
  • Platforms listed below:
    • E2600
    • E5400 and associated EF series
    • E5500 and associated EF series
    • E2700
    • E5600 and associated EF series


The following procedure is used to reset an E-Series storage array configuration back to initial settings. The article provides two methods for clearing the storage array configuration:

  • via SANtricity Management Software Application (Array Management Window)
  • via SANtricity Management Command Line Interface (SMCLI)


Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device