Skip to main content
NetApp Knowledge Base

SolidFire node will not add to the cluster and gives MTU failure error

  1. Last updated
  2. Save as PDF
Views:
69
Visibility:
Public
Votes:
0
Category:
h-series
Specialty:
solidfire
Last Updated:

Applies to

H610S

Issue

Node addition to an existing cluster fails with error message:
 
AddNodes Failed: Could not contact node_pendingNodeID=<NodeID> with packetSize=8972 sized MTU frames.  Cannot add nodes.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.