Skip to main content
NetApp Knowledge Base

ONTAP Select: HA interconnect issues on ONTAP Select because virtual networking best practices are not followed

  1. Last updated
  2. Save as PDF
Views:
483
Visibility:
Public
Votes:
0
Category:
ontap-select
Specialty:
virt
Last Updated:

Applies to

  • ONTAP Select
  • VMware vSphere vSwitch

Issue

HA failover is disabled because the RDMA Connection is down:

Note: This command is a diagnostic level command

cluster::*>interconnect status show
  (system ha interconnect status show)

                       Node: node-01
                Link Status: down
         IC RDMA Connection: down

                       Node: node-02
                Link Status: down
         IC RDMA Connection: down
2 entries were displayed.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.