Skip to main content
NetApp Knowledge Base

ONTAP Select Node, Boot Loop or Shutdown After Update VMware 8.0U3

  1. Last updated
  2. Save as PDF
Views:
1,121
Visibility:
Public
Votes:
0
Category:
ontap-select
Specialty:
ontapselect
Last Updated:

Applies to

  • NetApp ONTAP Select 9.15.1 or below
  • VMware ESXi 8.0U3
  • VMware vCenter 8.0U3

Issue

ONTAP Select node wont boot up after update VMware ESXi host to 8.0U3 (boot loop or shutdown)
 
The console has been disconnected. Close this window and re-launch the console to reconnect.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.