Skip to main content
NetApp Knowledge Base

ONTAP Deploy fails to delete decommissioned ONTAP Select Cluster

  1. Last updated
  2. Save as PDF
Views:
Visibility:
Public
Votes:
0
Category:
ontap-select
Specialty:
ontapselect
Last Updated:

Applies to

  • ONTAP Select clusters managed via VMware ESXi/vCenter
  • ONTAP Select Deploy Web UI and CLI

Issue

  • When attempting to delete unused ONTAP Select clusters from the ONTAP Select Deploy Web UI, the following error is displayed:
Failed to delete cluster "clustername. If the cluster has been reconfigured outside of ONTAP Select Deploy, run a refresh operation on the cluster, and then try the operation again.
  • The affected clusters have no node serial numbers detected in Deploy.
  • The corresponding ONTAP Select VMs are powered off and/or unreachable via management IP.
  • The “Refresh Cluster” option is not available in the Web UI for these clusters.
  • Attempts to delete via the Web UI fail consistently.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.