Skip to main content
NetApp Knowledge Base

Aggregate has both plexes in an out-of-date state causing nodes to be in a boot loop

  1. Last updated
  2. Save as PDF
Views:
42
Visibility:
Public
Votes:
0
Category:
ontap-select
Specialty:
ontapselect
Last Updated:

Applies to

  • ONTAP Select (OTS)
  • ONTAP 9

Issue

  • Two-node OTS cluster has both nodes continuously rebooting.
  • Root aggregate has both the plexes showing offline and out-of-date condition as seen in the following output of the command, aggr status -r:

image.png

  • The same can be confirmed in the output of the command, plex show:
image (1).png
 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.