Skip to main content
NetApp Knowledge Base

Useful commands for MetroCluster FC and IP switches

  1. Last updated
    May 4, 2023
  2. Save as PDF
Views:
861
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:
5/4/2023, 8:26:35 AM

Applies to

  • MetroCluster
  • Cisco
  • Brocade
  • Broadcom

Answer

In the below articles we have put together a list of the most commonly used commands for configuring, managing and troubleshooting MetroCluster switches.

Choose the article based on the type of MetroCluster in use:

MetroCluster FC (Brocade and Cisco) MetroCluster IP (Broadcom (BES) and Cisco)
Command Mapping between Cisco MDS and Brocade Switches Command mapping between Cisco switches and BES-53248

Additional Information

N/A

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.