Skip to main content
NetApp Knowledge Base

"Metrocluster operation show" displays a failed switchover simulate

  1. Last updated
  2. Save as PDF
Views:
103
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster IP
  • MetroCluster FC

Issue

  • Metrocluster operation show output is displaying a failed switchover simulate operation:

Node01-01::> metrocluster operation show
       Operation: switchover-simulate
           State: failed
      Start Time: 5/24/2024 17:04:35
        End Time: 5/24/2024 17:04:35
          Errors: Failed to set up the node and cluster components for the switchover operation.
                  Node01-01 (fatal): The following clusters are not peered with this cluster: Node01. Create a cluster peering relationship with these clusters, verify that the peer cluster is available using the "cluster peer show", then try the command again.

  • Cluster peering reports normal.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.