Skip to main content
NetApp Knowledge Base

Metrocluster measure errors

  1. Last updated
  2. Save as PDF
Views:
93
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster IP
  • DWDM
  • Measurements
  • Installation

Issue

  1. ::*> metrocluster configuration-settings calibration measure  shows the errors:

Did not receive a "ping" response using the network addresses "0.0.0.0" and "0.0.0.0" on node "node1" in cluster "node".

Internal error: bandwidth measurement failed. Reason: proc returned invalid output

  1. ::*> metrocluster configuration-settings calibration show

    Missing measure for a particular port
  2. SinglePathToDiskShelf_Alert in event logs

  3. Discards on the Intercluster Interfaces.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.