Skip to main content
NetApp Knowledge Base

MetroCluster switchover fails after ONTAP upgrade version mismatch

Views:
105
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster
  • ONTAP 9
  • ONTAP upgrade has completed

Issue

After an ONTAP upgrade metrocluster switchover and metrocluster switchover -simulate true fail with the following error:

Error: Unable to perform the MetroCluster operation because of a Data ONTAP version mismatch. All nodes in a MetroCluster configuration must have the same version for both the current and default images. Upgrade or revert nodes as needed, then try the command again.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.