Skip to main content
NetApp Knowledge Base

MetroCluster site cannot see remote drives

  1. Last updated
  2. Save as PDF
Views:
120
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • Fabric MetroCluster
  • ONTAP 9
  • DWDM used between sites

Issue

The nodes at one of the two sites are unable to see the remote disks, shelves & ATTO bridges
 
Example:
ClusterA::> system node run -node ClusterA-01 -command sysconfig -a                            
    slot 1: FC Host Adapter 1a (Emulex XE501 rev. 1, N-port, <UP>)
    ...
                FC-to-SAS Bridge:
                SiteA-SW1:1-11.126L0            : ATTO     FibreBridge7500N 3.30  FB7500N123456
                SiteA-SW1:1-9.126L0             : ATTO     FibreBridge7500N 3.30  FB7500N234567
    Missing --> SiteB-SW1:1-9.126L0             : ATTO     FibreBridge7500N 3.30  FB7500N654321
    Missing --> SiteB-SW1:1-11.126L0            : ATTO     FibreBridge7500N 3.30  FB7500N765432

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.