Skip to main content
NetApp Knowledge Base

MetroCluster IP which RCF version should be used

  1. Last updated
    May 26, 2023
  2. Save as PDF
Views:
494
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:
5/26/2023, 12:00:34 PM

Applies to

  • MetroCluster IP
  • ONTAP 9
  • Metrocluster IP backend switches

Answer

  1. Download and launch the RcfFileGenerator for MetroCluster IP
  2. Generate the new RCF as detailed in How to use the RcfFileGenerator for MetroCluster IP
  3. Select the latest RCF version from the RCF Version dropdown.
  4. Check the preview window for any switch firmware version prerequisites.
  5. If switch firmware version prerequisites are met, or are not specified, the selected RCF version can be used.
  6. If switch firmware version prerequisites are not met then repeat steps 3-5 selecting older versions until version prerequisites are met.

Additional Information

The RCF Generator will only generate RCFs for supported configurations.

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.