Skip to main content
NetApp Knowledge Base

How to manually trigger a MetroCluster AUSO

  1. Last updated
    Nov 22, 2023
  2. Save as PDF
Views:
87
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:
11/22/2023, 9:42:51 AM

Applies to

  • Fabric MetroCluster
  • ONTAP 9

Answer

  • Power down both nodes at the same site from the Service Processor using the command system power off
  • Do not power off the disk shelves or a manual forced-on-disaster switchover will be required.

Additional Information

N/A

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.