Skip to main content
NetApp Knowledge Base

How to configure Cisco Discovery Protocol (CDP) in a MetroCluster IP

Views:
1,700
Visibility:
Public
Votes:
2
Category:
not set
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster IP
  • CDP
  • ONTAP 9.6 and earlier

Description

This article describes how to enable CDP in a MetroCluster IP environment.

  • CDP should be enabled on all the nodes part of the MetroCluster IP prior to ONTAP 9.7
  • It is enabled by default in ONTAP for cluster ports, but must be enabled explicitly for the other ports.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.