Skip to main content
NetApp Knowledge Base

DR Config Replication alert due to wrong tcp-max-xfer-size

  1. Last updated
  2. Save as PDF
Views:
102
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster IP
  • ONTAP 9.6 and above

Issue

  • DR CONFIG REPLICATION FAILED autosupport

  • Vserver error on the cluster: Resynchronize the configuration using "metrocluster vserver resync" command. Contact technical support for assistance if configuration-state does not change to healthy.

  • Failed Reason: Cannot set "-tcp-max-xfer-size" to a value other than multiples of 4096.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.