Skip to main content
NetApp Knowledge Base

ATTO FibreBridge not configured correctly (loop-ptp)

Views:
724
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • ATTO FibreBridge
  • Fabric attached MetroCluster

Issue

  • ATTO FiberBridge not configured correctly:

ClusterA::> storage bridge show -field fc-port-oper-state-list,fc-port-negotiated-data-rate-list,fc-port-configured-conn-mode-list       
name             fc-port-oper-    fc-port-negotiated     fc-port-configured-
                 state-list       -data-rate-list        conn-mode-list
---------------  --------------   ------------------     ---------------------------------      
ATTO_10.10.10.4  online,offline   8gb,unknown            loop-preferred,loop-preferred  <== FCConnMode not set to ptp on FC port 1
4 entries were displayed.

  • ONTAP looses access to disks being the ATTO bridge due to the incorrect set connection mode 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.