Skip to main content
NetApp Knowledge Base

ARP mechanism is not working with X50132A adapter

  1. Last updated
  2. Save as PDF
Views:
33
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • ONTAP
  • MetroCluster IP
  • New Installation
  • Compliant Switches

Issue

  1. X50132A adapter card is connected to Cisco switches. 
  2. The MAC address can be seen on the switches but when pinging any device there is no reply.
  3. The ARP table no entry is visible for the controller.
  4. TCPDUMP shows that data is being transmitted but no reply is received
  5. Manually inserting the MAC address allow communication to take place.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.