Skip to main content
NetApp Knowledge Base

No disks attached to system after controller replacement in two node MetroCluster FlexArray solution

  1. Last updated
    Jan 16, 2024
  2. Save as PDF
Views:
335
Visibility:
Public
Votes:
0
Category:
ef-flash-array
Specialty:
hw
Last Updated:
1/16/2024, 7:25:35 AM

Applies to

  • FlexArray
  • Two nodes MetroCluster
  • E-Series 
  • Cisco MDS 9148S with PWWN Zoning

Issue

After a controller replacement, the new node is not detecting any disk, in maintenance mode:

*> disk show -v
Local System ID: 123456789
disk show: No disks attached to system.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.