Skip to main content
NetApp Knowledge Base

Is it possible to set the Junction Path before performing the first transfer for the DP volume created as the Snapmirror destination?

Views:
72
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9
  • SnapMirror
  • NDMP

Answer

  • Although it is possible to set the Junction Path for the SnapMirror Destination volume before the initial transfer, it is usually set after the transfer.
  • However, even if configured, data access through the Junction Path will not be possible until the initial transfer is complete and the volume is ready for reading/writing.

Additional Information

additionalInformation_text

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.