Skip to main content
NetApp Knowledge Base

Interface group port participation shows partial or none

  1. Last updated
  2. Save as PDF
Views:
617
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP9
  • Networking

Issue

  • After configuring new ifgroup on NetApp cluster, only one port out of four in two ifgroup is green. This is caused by discrepancy between the LAG (Link Aggregation Group) configuration on the switch end and cable mapping between the storage and switch ports.
  • From the output of "ifgrp show" we see only one port up.
Node: Cluster_1_Node1
Interface Group Name: a0b
Distribution Function: ip
        Create Policy: multimode_lacp
          MAC Address: xx:xx:xx:xx:xx:xx
   Port Participation: partial
        Network Ports: e0e, e0f
             Up Ports: e0e
           Down Ports: e0f
 
Node: Cluster_1_Node2
Interface Group Name: a0b
Distribution Function: ip
        Create Policy: multimode_lacp
          MAC Address: xx:xx:xx:xx:xx:xx
   Port Participation: none
        Network Ports: e0e, e0f
             Up Ports: -
           Down Ports: e0e, e0f
4 entries were displayed.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.