Skip to main content
NetApp Knowledge Base

DNS create fails due to lack of network reachability

Views:
2,879
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
nas
Last Updated:

Applies to

  • ONTAP 9
  • DNS

Issue

  • The command dns create fails with the following error:

::> vserver services name-service dns create -vserver svm1 -domains domain1.local -name-servers 10.xx.xx.20

Error: command failed: Failed to verify the specified DNS configuration.
       10.xx.xx.20: No route to host.
       Verify that the network configuration is correct and that DNS servers are available. Specify "-skip-config-valid           ation" to skip the configuration validation.

  • DNS Check fails ( If DNS CREATE with -skip-config-validation was already run)
::> dns check -vserver hnasbond007   (svm)
                              Name Server
Vserver       Name Server     Status       Status Details
------------- --------------- ------------ --------------------------
svm1         10.xx.xx.20       down         Network is unreachable.
  • Ping to the DNS IP fails:

::> network ping -lif lif1 -vserver svm1 -destination 10.xx.xx.20

no answer from 10.xx.xx.20

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.