Skip to main content
NetApp Knowledge Base

How to zero spare drives for reconstruction

  1. Last updated
    Nov 2, 2022
  2. Save as PDF
Views:
4,823
Visibility:
Public
Votes:
3
Category:
data-ontap-8
Specialty:
HW
Last Updated:
11/2/2022, 10:00:00 AM

​

​

Applies to

  • ONTAP 9
  • Clustered Data ONTAP 8.3
  • Clustered Data ONTAP 8.2
  • Data ONTAP 8.2 7-Mode

Description

Error message: /vol0/plex0/rg0/0a.45 (S/N XXXXX): disk failure detected
Earlier versions of Data ONTAP might display a message similar to the following:

Error message: ERROR: unable to start reconstruction for /vol0/plex0/rg0: No zeroed disk of correct size available

(For more information, see BUG 85383)
The No zeroed disk of correct size available message is displayed after a drive has failed, although there are spares of the same size.
A disk failure message occurs.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.