Skip to main content
NetApp Knowledge Base

EMS log reports the event "spm.mgwd.process.exit"

Last Updated:

Applies to

  • ONTAP 9.3
  • ONTAP 9.4
  • AutoSupport (ASUP)
  • Command Line Interface (CLI)


  • CLI is disrupted during the AutoSupport information collection process - no disruption to data service
  • EMS log reports the event "spm.mgwd.process.exit".
::> event log show -node node1
Time Node Severity Event
------------------- ---------------- ------------- ---------------------------
5/24/2020 00:27:00 node1 EMERGENCY spm.mgwd.process.exit: Management Gateway (mgwd) subsystem with ID 59187 exited as a result of signal signal 11. The subsystem will attempt to restart.
5/24/2020 00:26:50 node1 ERROR ucore.panicString: 'mgwd: Received SIGSEGV (Signal 11) at RIP 0x80b8427e4 accessing address 0xffffffffffffffe8 (pid 59187, uid 0, timestamp 1590247610)'


Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.


  • Was this article helpful?