Skip to main content
NetApp Knowledge Base

Deleted volumes not in the Volume Recovery Queue

  1. Last updated
  2. Save as PDF
Views:
41
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9
  • Volume Recovery Queue (VRQ)

Issue

  • After deleting volumes  they are not listed in the VRQ while still within the retention window.

cluster1::>set diag

cluster1::*> vserver show -fields volume-delete-retention-hours
vserver volume-delete-retention-hours
------- -----------------------------
Cluster -
cluster1 -
cluster1-01 -
cluster1-02 -
svm1_cluster1 12
svm2_cluster1 12
6 entries were displayed.


cluster1::*> volume recovery-queue show
This table is currently empty.

  • In the above output the vserver was  named test and the vserver was deleted.  Prior to the vserver delete the volumes were in the VRQ: 
cluster1::*> volume recovery-queue show
Vserver   Volume      Deletion Request Time     Retention Hours
--------- ----------- ------------------------  ---------------
test      test2_1029  Fri Jul 04 20:31:16 2025               12
test      test3_1030  Fri Jul 04 20:31:44 2025               12
2 entries were displayed.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.