Skip to main content
NetApp Knowledge Base

Cluster switch not shown in the output of the "System Cluster-Switch Show" command

  1. Last updated
  2. Save as PDF
Views:
749
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • Cluster network switches

Issue

  • The cluster switches are not reported in the output of the system cluster-switch show or system switch ethernet show commands.
  • The switches are fully functional, and all the cluster port links are up.
  • The following health alert will be generated in the event logs:

[node: cshmd: hm.alert.raised:alert]: Alert Id = SwitchlessConfig_Alert , Alerting Resource = cluster raised by monitor cluster-switch

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.