Skip to main content
NetApp Knowledge Base

Cannot Create Volume During SVM Migration

  1. Last updated
  2. Save as PDF
Views:
3
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

ONTAP 9

Issue

  • Attempts to create a new volume on a Storage Virtual Machine (SVM) fail with an error message indicating that the Vserver (SVM) is migrating. The following is observed in the CLI and mgwd logs:
Failed to perform action create: volume:{vserver:SVM1, volume:demo_vol, ...}. Reason: The operation failed because Vserver "SVM1" is migrating. Retry the operation after the Vserver migrate completes or after pausing the migration using the "vserver migrate pause -vserver SVM1" command on destination cluster "Cluster1".
  • Volume creation fails via both CLI and GUI.
  • Error message references ongoing Vserver (SVM) migration.
  • Volume is not created until migration completes or is paused.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.