Skip to main content
NetApp Knowledge Base

Can cluster switch RCF file be upgraded without wiping the existing configuration?

  1. Last updated
  2. Save as PDF
Views:
879
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

  • Cisco Nexus (NX) Cluster Network Switches
  • BES-53248 Cluster Network Switch

Answer

No ,  Any modification to the standard RCF should be reapplied after the upgrade

  • Modifications to the RCF configurations are limited 
  • Manual modifications that would keep alive a continuous remote connectivity to the switch mgmt0 IP are not recommended.
    • A console connection to the switch is required when installing the RCF.
  • Consult the following documentation for installing and upgrading the Reference Configuraion File (RCF) on Broadcom BES and Cisco NX switches:

Additional Information

 

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.