Skip to main content
NetApp Knowledge Base

Can Cluster send SNMP get-request?

  1. Last updated
  2. Save as PDF
Views:
412
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

ONTAP 9

Answer

Yes. CSHM daemon runs on a single node in the cluster and uses the management LIF to monitor the devices with SNMP.

Run the following command to be disabled send SNMP get-request:
::>node run -node * options cdpd.enable off

Additional Information

N/A

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.