Aggregates in unknown state after config restore test
Applies to
Issue
- A configuration backup restore was tested and aggregates are in '
unknown' state:
Cluster::> aggr show
Aggregate Size Available Used% State #Vols Nodes RAID
Status
--------- -------- --------- ----- ------- ------ ---------------- ------------
aggr0_node1 - - - unknown - node1 -
aggr0_node2 - - - unknown - node2 -
aggr1_node1 - - - unknown - node1 -
aggr1_node2 - - - unknown - node2 -
4 entries were displayed.
- Only a root aggregate has been created during the restoration :
Cluster::> system node run -node node* -c sysconfig -r
2 entries were acted on.
Node: node1
Aggregate aggr0_node1 (online, raid_dp) (block checksums)
Plex /aggr0_node1/plex0 (online, normal, active, pool0)
RAID group /aggr0_node1/plex0/rg0 (normal, block checksums)
RAID Disk Device HA SHELF BAY CHAN Pool Type RPM Used (MB/blks) Phys (MB/blks)
--------- ------ ------------- ---- ---- ---- ----- -------------- --------------
dparity 0a.00.18P3 0a 0 18 SA:A 0 SSD N/A 147102/301265408 147110/301281792
parity 0d.00.19P3 0d 0 19 SA:B 0 SSD N/A 147102/301265408 147110/301281792
data 0a.00.20P3 0a 0 20 SA:A 0 SSD N/A 147102/301265408 147110/301281792
data 0d.00.21P3 0d 0 21 SA:B 0 SSD N/A 147102/301265408 147110/301281792
data 0a.00.22P3 0a 0 22 SA:A 0 SSD N/A 147102/301265408 147110/301281792