Skip to main content
NetApp Knowledge Base

CONTAP-485871: CLI command "security key-manager onboard sync" fails to complete

  1. Last updated
  2. Save as PDF
Views:
393
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Issue

  • When the Onboard Key Manager (OKM) is enabled, users may run  the "security key-manager onboard sync" CLI command in multiple situations, including the following:
    • A controller's motherboard or boot device needs to be replaced.
    • Additional nodes are added to the cluster.
  • In these case the "security key-manager onboard sync" command may fail to successfully complete.

Error: command failed: The Onboard Key Manager has synced on the local node "Node-01". The following nodes in the cluster are not reachable or failed to sync: Node-02. Use the "cluster show" command to check a node's health status and then run the "security key-manager onboard sync" command again.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.