Skip to main content
NetApp Knowledge Base

Switchover vetoed due to Vserver in deleting state

  1. Last updated
    Nov 6, 2023
  2. Save as PDF
Views:
86
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:
11/6/2023, 1:26:22 PM

Applies to

  • Metrocluster
  • ONTAP 9

Issue

  • Switchover failed due to:
Operation: switchover-simulate
          State: failed
         Errors: Failed to validate the node and cluster components before the switchover operation.
                 NodeB (non-overridable veto): Internal error: Unable to lock Vservers, Reason: Vserver admin state check failed. Run "vserver show" to verify that the "Admin State" of all "sync-source" Vservers is not "deleting", and then try the command again. Contact technical support for assistance.
  • vserver show -admin-state deleting is displaying source vserver stuck in deleting state.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.