Skip to main content
NetApp Knowledge Base

D_Port test in NOT STARTED state

  1. Last updated
  2. Save as PDF
Views:
608
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • Brocade switches
  • Fabric MetroCluster

Issue

When running the D_Port test, it remains in a 'NOT STARTED' state.

Example:

S1Switch01:admin> portdporttest --show 0
D-Port Information:
===================
Port:                           0
Remote WWNN:                    10:00:d8:1f:cc:10:86:2a
Remote port index:              0
Mode:                           Automatic
No. of test frames:             1 Million
Test frame size:                1024 Bytes
Pattern:                        jCRPAT
FEC (enabled/option/active):    Yes/No/No
CR (enabled/option/active):     Yes/No/No
Start time:                     Mon Dec  7 13:26:16 2020
End time:                       -------------------
Status:                         NOT STARTED
================================================================================
Test                    Start time      Result          EST(HH:MM:SS)   Comments
================================================================================
Electrical loopback     --------        NOT STARTED     --------        ----------
Optical loopback        --------        NOT STARTED     --------        ----------
Link traffic test       --------        NOT STARTED     --------        ----------
================================================================================
Roundtrip link latency:         unknown
Egress power:                   Tx: -2.0 dBm, Rx: Not Avail.
Ingress power:                  Rx: -4.8 dBm, Tx: Not Avail.

S2Switch01:admin> portdporttest --show 0
D-Port Information:
===================
Port:                           0
Remote WWNN:                    10:00:d8:1f:cc:10:86:2a
Remote port index:              0
Mode:                           Automatic
No. of test frames:             1 Million
Test frame size:                1024 Bytes
Pattern:                        jCRPAT
FEC (enabled/option/active):    Yes/No/No
CR (enabled/option/active):     Yes/No/No
Start time:                     Mon Dec  7 13:26:31 2020
End time:                       -------------------
Status:                         NOT STARTED
================================================================================
Test                    Start time      Result          EST(HH:MM:SS)   Comments
================================================================================
Electrical loopback     --------        NOT STARTED     --------        ----------
Optical loopback        --------        NOT STARTED     --------        ----------
Link traffic test       --------        NOT STARTED     --------        ----------
================================================================================
Roundtrip link latency:         unknown
Egress power:                   Tx: -2.5 dBm, Rx: Not Avail.
Ingress power:                  Rx: -3.5 dBm, Tx: Not Avail.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.