Skip to main content
NetApp Knowledge Base

Automatic switchover not triggered during site power failure

  1. Last updated
  2. Save as PDF
Views:
6
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster IP 
  • ONTAP 9

Issue

Following a site-wide power failure at one MetroCluster location (for example, “Site A”), both nodes at that site became unavailable. An automatic switchover at the remote MetroCluster site (for example, “Site B”) was expected to maintain data access; however, the switchover did not occur automatically. As a result, a service disruption was experienced until a manual intervention was performed.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.