Skip to main content
NetApp Knowledge Base

Snapmirror show output is blank after cloud maintenance

  1. Last updated
  2. Save as PDF
Views:
146
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • Cloud Volumes ONTAP
  • ONTAP 9.0 and later

Issue

After Cloud maintaianance window and automatic takeover/giveback of nodes, snapmirror show output for one or more volumes is blank.
cluster::> snapmirror show
Source            Destination Mirror  Relationship   Total             Last
Path        Type  Path        State   Status         Progress  Healthy Updated
----------- ---- ------------ ------- -------------- --------- ------- --------
snap_src1:snapmirror_src1 XDP svm_dst1:snapmirror_src1_dest -   -   -   -   -
snap_src1:snapvault_src1 XDP svm_dst1:snapvault_src1_dest Snapmirrored Idle - true -
2 entries were displayed.
 
Manual snapmirror update resulted in below error.
Error: command failed: Relationship information has been updated and is being propagated. Wait a few minutes and try the command again.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.