Skip to main content
NetApp Knowledge Base

SnapMirror transfer stuck at 0 bytes

  1. Last updated
  2. Save as PDF
Views:
280
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9.13.1RC1 through ONTAP 9.13.1P7
  • SnapMirror

Issue

  • The SnapMirror source cluster is running ONTAP 9.13.1RC1 through ONTAP 9.13.1P7
  • New and existing SnapMirrors report a Transferring status but no progress is made
  • Progress may report zero bytes or non-zero bytes but does not increment
  • No failures are observed in snapmirror show output or within SnapMirror-Audit logs
  • snapmirror abort works but restarting the transfer shows the same behavior
  • SnapMirror source node(s) report either of the following EMS messages:

wafl.memory.statusLowMemory:notice
wafl.memory.statusVeryLowMemory:alert

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.