Skip to main content
NetApp Knowledge Base

SnapMirror transfer stuck at 0 bytes and "volume show" take long time to execute

  1. Last updated
  2. Save as PDF
Views:
101
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • SnapMirror
  • FAS 8200

Issue

  • SnapMirror transfer stuck at 0 bytes
  • The volume show execution takes a very long time to complete on the SnapMirror destination volume
  • Rebooting both nodes does not solve the problem
  • After re-initializing the destination cluster system, the Cluster Setup process takes more than 20 minutes to complete.
  • The DP volume fails to be offlined and deleted

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.