SnapMirror for Flexgroup Volume fails with "Relationship information has been updated and is being propagated"
Applies to
- SnapMirror
- FlexGroup
- ONTAP 9.x
- Persistent failure of SnapMirror commands with:
Relationship information has been updated and is being propagated. Wait a few minutes and try the command again
Issue
- Snapmirror update via System Manager fails with:
“ONTAP API Failed: Relationship information has been updated and is being propagated. Wait a few minutes and try the command again. (Error: 13001)”
- On a SnapMirror destination, SnapMirror commands run against a FlexGroup volume fail with the error:
Relationship information has been updated and is being propagated. Wait a few minutes and try the command again.
- SnapMirror commands persistently fail with the same message, even after waiting a few minutes (or longer period of time)
Note: If, after receiving the above error, later attempts to run SnapMirror commands succeed, the cause and solution in this KB does not apply
- The SnapMirror destination Sktrace log contains:
SM_HIGH_4: [sm_rpl_admin_cg_mgmt.c:4077]: Cache: resume CG[<vol_name>] : failed - CG not present in cache. = 0
Note: AutoSupport sktrace section may not contain the above message. A manual collection of all sktrace logs, and search of the collected logs, is recommended