Skip to main content
NetApp Knowledge Base

SnapMirror becomes slow after transferring an amount of data

  1. Last updated
  2. Save as PDF
Views:
2,230
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • SnapMirror
  • Amazon FSx for ONTAP

Issue

  • SnapMirror network throughput reports lower after transferring an initial amount of data with higher throughput
  • No performance impact seen on the Source
  • The destination shows a medium to high disk load
  • Little or no data transfer is seen on the interconnect

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.