Skip to main content
NetApp Knowledge Base

SnapMirror Sync reverse resync fails after Disaster Recovery

Views:
111
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9.11.1P8
  • SnapMirror Synchronous

Issue

  • SNAPMIRROR-AUDIT Failure messages:
Destination SRC_PRD_01:vol1 must be a data-protection volume.
Failed to change the volume SRC_PRD_01:vol1 to data-protection.(Volume busy)
 
  • EMS-LOG
config_async_0: wafl.offline.volref.msg:notice]: 'batch_css_delete' prevents 'remount' of 'volume vol1'

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.